Hyundai Santa Fe (DM): BJ Boot. Repair procedures - Driveshaft Assembly - Driveshaft and axleHyundai Santa Fe (DM): BJ Boot. Repair procedures

Removal

1.
Remove the front driveshaft.
2.
Remove the TJ joint assembly.
3.
Remove the Dynamic damper.
4.
Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).

5.
Remove the BJ boot.
6.
Install in the reverse order of removal.
•
Do not disassemble the BJ assembly.
•
Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
•
The boot band should be replaced with a new one.
7.
Check the front alignment.

BJ Boot. Components and Components Location
Components 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Dynamic damper band 6. Dynamic damper 7. Shaft 8. TJ boot band 9. TJ boot 10. Spider assembly 11. Retainer ring 12. TJ housing 13. ...

See also:

ETC (Electronic Throttle Control) System. Troubleshooting
Fail-Safe Mode Item Fail-Safe ETC Motor Throttle valve stuck at 5° TPS TPS 1 fault ECM looks at TPS2 TPS 2 fault ECM looks at TPS1 TPS 1,2 fault Throttle valve stuck at 5° APS APS 1 fault ECM looks at ...

A/V Mode
This mode displays the state of the A/V system. ...

SS-B Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-B) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) Internal resistance(Ω) 10~11 ...