Body (Interior and Exterior)

Hyundai Santa Fe: Body (Interior and Exterior)

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior)

General Information

Body Dimensions

Fender

Hood

Tail Gate

Fuel Filler Door

Front Door

Rear Door

Body Side Molding

Panorama sunroof

Mirror

Cowl Top Cover

Floor Console

Crash Pad

Roof Trim

Interior Trim

Trunk Trim

Repair procedures

Windshield Glass

Quarter Fixed Glass

Floor Carpet

Repair procedures

Front Bumper

Rear Bumper

Front Seat

Rear Seat

Front Seat Belt

Rear Seat Belt

Steering Angle Sensor. Description and Operation

Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction ...

General Information

...

See also:

Charging System Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When there is a malfunction with either the ...

Start/Stop Button. Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Disconnect the start/stop button connector (B) after removing the center fascia garnish (A). 4. Remove ...

General Service Information
General Service Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod must be inserted into the hole near the edge of the hood ...