Hyundai Santa Fe (DM): Cluster Fascia Panel. Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Santa Fe (DM): Cluster Fascia Panel. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Lower the steering wheel.
2.
Using a screwdriver or remover, remove the steering column shroud upper panel (A).
3.
Using a screwdriver or remover, remove the cluster fascia upper panel (A).
4.
Install in the reverse order of removal.
•
Replace any damaged clips.

Cluster Fascia Panel. Components and Components Location
Component Location 1. Cluster fascia upper panel ...

Crash Pad Lower Panel. Components and Components Location
Component Location 1. Crash pad lower panel ...

See also:

Repair procedures
Adjustment Inspect Glass Alignment 1. Inspect the alignment of the movable glass (C) that is between the front (A) and rear (B) glass and if needed adjust it. Alignment adjustment Standard value [mm(in.)] ...

Transaxle Control Module (TCM). Repair procedures
Removal When replacing the TCM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used TCM] 1. Perform "TCM Neutral mode" procedure with ...

Input Speed Sensor. Specifications
Specifications ▷ Type: Hall effect sensor Operation condition (°C)°F ((-)40~150)) -40~302 Air gap(mm)in. (0.95~1.65) 0.0374~0.0649 Output voltage(V) High 1.18~1.68 Low 0.59~0.84 ...