Hyundai Santa Fe (DM): Crach Pad Center Panel. Repair procedures
Replacement
|
|
1. |
Remove the console front complete assembly.
|
2. |
Remove the crash pad lower panel.
|
3. |
Remove the glove box housing.
|
4. |
Remove the heater control unit.
|
5. |
After loosening the mounting screw, then remove the crash pad
garnish [LH] (A).
|
6. |
After loosening the mounting screws, then remove the center crash
pad cover (A).
[LH]
[RH]
|
7. |
After loosening the mounting screws, then remove the crash pad
center lower panel (A).
|
8. |
Disconnect the console under lamp connector (A).
|
9. |
Install in the reverse order of removal.
|
Crach Pad Center Panel. Components and Components Location
Component Location 1. Crash pad center lower panel ...Main Crash Pad Assembly. Components and Components Location
Component Location 1. Main crash pad assembly ...See also:
Rear Body. Body Repair
* These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side outer panel rear corner Tail gate hinge mounting hole (Ø12) Tail gate hinge mounting hole ...
Seat belt warning (for driver’s seat)
The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1Warning pattern repeats 11 times with an interval of 24 ...
Rail Pressure Sensor (RPS). Schematic Diagrams
Circuit Diagram ...