Hyundai Santa Fe (DM): Crankshaft Position Sensor (CKPS). Description and Operation
Description
Crankshaft Position Sensor (CKPS) detects the crankshaft position and
is one of the most important sensors of the If there is no CKPS signal input,
the engine may stop because of CKPS signal missing. This sensor is installed
on the cylinder block or the transaxle housing and generates alternating current
by magnetic flux field which is made by the sensor and the target wheel when
engine runs.
The target wheel consists of 58 slots and 2 missing slots on 360 degrees
CA (Crank Angle).
Engine Coolant Temperature Sensor (ECTS). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Remove the ECTS (Refer to "Removal"). 3. After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals ...
Crankshaft Position Sensor (CKPS). Troubleshooting
Wave Form ...
See also:
General Information. Repair procedures
Compression Pressure Inspection If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure. 1. Warm up and stop engine. Allow the engine to warm up ...
Heating and air conditioning
1. Start the engine. 2. Set the mode to the desired position. To improve the effectiveness of heating and cooling : - Heating: - Cooling: 3. Set the temperature control to the desired position. 4. Set ...
Cowl Cross Bar Assembly. Components and Components Location
Component Location 1. Cowl cross bar assembly ...
