Hyundai Santa Fe (DM): Crash Pad Lower Panel. Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Santa Fe (DM): Crash Pad Lower Panel. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Using a screwdriver or remover, remove the crash pad side cover [LH] (A).
2.
After loosening the mounting screws, then remove the crash pad lower panel (A).
3.
Disconnect the diagnosis connector (A).
4.
Install in the reverse order of removal.
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.

Crash Pad Lower Panel. Components and Components Location
Component Location 1. Crash pad lower panel ...

Glove Box Housing. Components and Components Location
Component Location 1. Glove box housing ...

See also:

Air cleaner
Filter replacement It must be replaced when necessary, and should not be washed. You can clean the filter when inspecting the air cleaner element. Clean the filter by using compressed air. 1. Loosen the ...

Driving on grades
Reduce speed and shift to a lower gear before you start down a long or steep downgrade. If you don’t shift down, you might have to use your brakes so much that they would get hot and no longer operate ...

Battery. Troubleshooting
Troubleshooting ...