Hyundai Santa Fe (DM): Cruise control system - Driving your vehicleHyundai Santa Fe (DM): Cruise control system

1.Cruise indicator

1.Cruise indicator
2.Cruise set indicator

The cruise control system allows you to program the vehicle to maintain a constant speed without depressing the accelerator pedal.

This system is designed to function above approximately 25 mph (40 km/h).

WARNING

  • If the cruise control is left on, (CRUISE indicator light in the instrument cluster is illuminated), the cruise control can be switched on accidentally. Keep the cruise control system off (CRUISE indicator light OFF) when the cruise control is not in use, to avoid inadvertently setting a speed.
  • Use the cruise control system only when driving on open highways in good weather.
  • Do not use the cruise control when it may not be safe to keep the vehicle at a constant speed, for instance, driving in heavy or varying traffic, or on slippery (rainy, icy or snowcovered) or winding roads or over 6% up-hill or down-hill roads.
  • Pay particular attention to the driving conditions whenever using the cruise control system.
  • Be careful when driving downhill using the cruise control system, which may increase the vehicle speed.

✽ NOTICE

  • During normal cruise control operation, when the SET switch is activated or reactivated after applying the brakes, the cruise control will energize after approximately 3 seconds. This delay is normal.
  • To activate cruise control, depress the brake pedal at least once after turning the ignition switch to the ON position or starting the engine. This is to check if the brake switch which is important part to cancel cruise control is in normal condition.
Good braking practices
WARNING Whenever you leave or park your vehicle, always set the parking brake as far as possible and fully engage the vehicle's transaxle into the P (Park) position. If the parking brake is not fully ...

Cruise control switch
CRUISE : Turns cruise control system on or off. CANCEL: Cancels cruise control operation. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise control speed. ...

See also:

Cooling Fan. Description and Operation
Description Control the cooling motor voltage in according to the duty(300Hz) of ECM. [ECU → PWM Input Signal(SI : 300Hz)] SI Duty Motor Voltage (V)   10% 0 ─ 30% 4.1 В± 0.65 60% 8.2 ...

Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...

Description and Operation
Function Of Safety Power Window When driver door power window auto-up switch is operated, safety function is activated. 1. Safety function condition When detect the force of 100N (using the 10N/mm spring) ...