Hyundai Santa Fe (DM): Curtain Airbag (CAB) Module. Repair procedures - Airbag Module - RestraintHyundai Santa Fe (DM): Curtain Airbag (CAB) Module. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / Airbag Module / Curtain Airbag (CAB) Module. Repair procedures

Removal

1.
Disconnect the battery negative cable and wait for at least 3 minutes before beginning work.
2.
Remove the roof trim.
3.
Disconnect the curtain airbag harness connector (A).
4.
After loosening the mounting bolts and nuts remove the curtain airbag.

Installation

1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three minutes.
3.
Tighten the curtain airbag mounting bolts and nuts.
Tightening torque
Bolt : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
Nunt : 3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)
•
Never twist the airbag module when installing it. If the module is twisted, airbag module may operate abnormally.
4.
Connect the curtain airbag connector.
5.
Install the roof trim.
6.
Reconnect the battery negative cable.
7.
After installing the curtain airbag (CAB), confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Curtain Airbag (CAB) Module. Components and Components Location
Components ...

Knee Airbag (KAB) Module. Description and Operation
Description The Knee Airbag (KAB) is installed inside the crash pad lower panel and protects the driver in the event of a frontal crash. The SRSCM determines if and when to deploy the KAB. Never attempt ...

See also:

Front Seat Belt Pretensioner. Repair procedures
Replacement • When installing the belt, make sure not to damage the pretensioner. 1. Remove the center pillar upper trim. 2. After loosening the mounting bolt, then remove the front seat belt upper anchor ...

Purge Control Solenoid Valve (PCSV). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the PCSV connector. 3. Measure resistance between the PCSV terminals 1 and 2. 4. Check that the resistance is within the specification. Specification: ...

Limitation of Active ECO operation
If the following conditions occur while Active ECO is operating, the system operation is limited even though there is no change in the ECO indicator. When the coolant temperature is low: The system will ...