Hyundai Santa Fe (DM): DBC Switch. Repair procedures - ESC(Electronic Stability Control) System - Brake SystemHyundai Santa Fe (DM): DBC Switch. Repair procedures

Inspection

1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the crash pad lower panel.
3.
Remove the crash pad side switch assembly (A) after loosening the screws.

4.
Check the continuity between the switch terminals as the DBC switch is engaged.


DBC Switch. Description and Operation
Description The DBC function is the acronym word of Downhill Brake Control function. When a vehicle goes down the hill, just pushing the DBC switch enables the car to keep its vehicle's speed at a ...

Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction ...

See also:

Side Body. Body Repair
Side Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side Body B * These dimensions indicated in this figure are actual-measurement dimensions. ...

Fuel Filler Door Release Actuator. Repair procedures
Inspection 1. Remove the left luggage side trim. 2. Remove the subwoofer. 3. Remove the fuel filler housing after opening the fuel filler door. 4. Loosen the fuel filler actuator mounting bolts (2EA). ...

Heated Repair procedures
Inpection 1. Measure a resistance of NTC and Heated pad. A. NTC resistance(Black / Yellow, Black) - 10.0 kΩ ± 10% (25°C) B. Heated pad resistance (Yellow, Black) - 1.6 ~ 2.0 Ω ± 10% 2. Measure ...