Hyundai Santa Fe (DM): Defroster - Features of your vehicleHyundai Santa Fe (DM): Defroster

CAUTION

To prevent damage to the conductors bonded to the inside surface of the rear window, never use sharp instruments or window cleaners containing abrasives to clean the window.

✽ NOTICE

If you want to defrost and defog the front windshield, refer to “Windshield defrosting and defogging” in this section.

Rear window defroster

Manual climate control

Manual climate control

Automatic climate control

Automatic climate control

The defroster heats the window to remove frost, fog and thin ice from the rear window, while the engine is running.

To activate the rear window defroster, press the rear window defroster button located in the center facia switch panel.

The indicator on the rear window defroster button illuminates when the defroster is ON.

If there is heavy accumulation of snow on the rear window, brush it off before operating the rear defroster. The rear window defroster automatically turns off after approximately 20 minutes or when the ignition switch is turned off. To turn off the defroster, press the rear window defroster button again.

Outside rearview mirror defroster (if equipped)

If your vehicle is equipped with the outside rearview mirror defrosters, they will operate at the same time you turn on the rear window defroster.

Front wiper deicer (if equipped)

If your vehicle is equipped with the front wiper deicer, it will be operating at the same time you operate the front windshield defroster.

Welcome system
Headlamp welcome When the headlight(light switch in the headlight or AUTO position) is on and all doors (and tailgate) are locked and closed, the headlight, position light and tail light will come on for ...

Manual climate control system
1. MAX A/C (Max air conditioning) button 2. A/C (Air conditioning) button 3. Mode selection buttons 4. Fan speed control knob 5. Rear window defroster button 6. Front windshield defrost button 7. Temperature ...

See also:

Schematic Diagrams
System Block Diagram Component Parts And Function Outline Component part Function Vehicle-speed sensor Converts vehicle speed to pulse. ECM Receives signals from sensor and control switches. Cruise control ...

LCD display control
The LCD display modes can be changed by using the control buttons. Information When the infotainment system is applied, only the User’s Setting mode on the infotainment system is supported but the User’s ...

Delivery Pipe. Repair procedures
Removal In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. So don’t do any repair ...