Hyundai Santa Fe (DM): Door Mood Lamp. Repair procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
|
| 3. |
Disconnect the door mood lamp connectors (A).
|
| 4. |
Remove the door mood lamp (A) after loosening the
screws (3EA).
|
| 5. |
If it is necessary to replace the bulb, replace the
bulb (A) after disconnecting the connector.
|
Installation
| 1. |
Install the door mood lamp and connector.
|
| 2. |
Install the front door trim.
|
| 3. |
Connect the negative (-) battery terminal.
|
Overhead Console Lamp. Repair procedures
Inspection 1. Remove the overhead console lamp assembly then check for continuity between terminals. If the continuity is not as specified, replace the map lamp switch. [General] [Panorama Sunroof] Removal ...
Hazard Lamp Switch. Repair procedures
Inspection 1. The SJB can be diagnosed by using the GDS. The SJB communicates with the GDS which then displays inputs and outputs along with codes. It will be able to diagnose defects of hazard lamp switch ...
See also:
Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may be determined by the following: Reference the device owner's manual for verification. The handheld transmitter ...
Description and Operation
System Overview RPAS (Rear Parking Assist System) is an electronic driving aid that warns the driver to be cautious while parking or in low speed environments. The sensor uses ultrasonic waves to detect ...
Components and Components Location
Component Location 1. Windshield deicer relay (Built-in engine room relay box) 2. Windshield deicer switch (Dual type) 3. Windshield deicer switch (Manual type) 4. Windshield deiecr 5. Deicer connector ...
