Hyundai Santa Fe (DM): Drive Belt. Repair procedures
Removal and Installation
1. |
For release the tension, turn the drive belt tensioner
counterclockwise then remove the drive belt (A).
|
2. |
Install the drive belt (A).
Rotate the drive belt tensioner arm (A) counterclockwise
moving the tensioner pulley bolt with wrench. After putting the belt
on the tensioner pulley, release the tensioner pulley slowly.
Crankshaft pulley → A/C pulley → Alternator pulley
→ Idler #1 pulley → Idler #2 pulley → Water pump pulley → Tensioner
pulley.
|
Inspection
1. |
Visually check the belt for excessive wear, frayed
cords etc.
If any defect has been found, replace the drive belt.
|
Components and Components Location
Components 1. Intake camshaft 2. Exhaust camshaft 3. Intake CVVT assembly 4. Exhaust CVVT assembly 5. Timing chain 6. Timing chain guide 7. Timing chain tensioner arm 8. Timing chain tensioner 9. Timing ...Idler. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the idler(A). Tightening torque : 53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft) Check the idler. if it is grease leak or abnormal rotation, ...See also:
Exterior Overview
Exterior Overview (Front View) 1. Hood 2. Headlight 3. Tires and wheels 4. Side view mirror 5. Sunroof 6. Front windshield wiper blades 7. Windows 8. Front ultrasonic sensors Exterior Overview (Rear View) ...
Rear Coil Spring. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...
Auto defogging system
Auto defogging reduces the probability of fogging up the inside of the windshield by automatically sensing the moisture of inside the windshield. The auto defogging system operates when the heater or ...