Hyundai Santa Fe (DM): Drive Plate. Repair procedures - Cylinder Block - Engine Mechanical SystemHyundai Santa Fe (DM): Drive Plate. Repair procedures

Removal and Installation

1.
Remove the automatic transaxle .
2.
Remove the drive plate (A) and the adapter plate (B).
Tightening torque :
117.7 ~ 127.5 N.m (12 ~ 13 kgf.m, 86.8 ~ 94.0 lb-ft)

•
Always use new drive plate (or flywheel) bolts.
•
Apply sealant to the screw part (10mm from the end of the bolt) when reusing the drive plate bolts.
Sealant: Three bond 2403, Loctite 200 or 204
•
Install and uniformly tighten the 7 bolts, in several passes.
3.
Install in the reverse order of removal.

Components and Components Location
Components 1. Piston ring 2. Snap ring 3. Piston 4. Connecting rod 5. Connecting rod upper bearing 6. Piston pin 7. Connecting rod lower bearing 8. Connecting rod bearing cap 9. Ladder frame 10. Oil filter ...

Rear Oil Seal. Repair procedures
Removal 1. Remove the automatic transaxle. 2. Remove the drive plate. 3. Rmove the rear oil sela(A). Installation 1. Install rear oil seal. (1) Apply engine oil to a new oil seal lip. (2) Using SST(09231-H1100, ...

See also:

Components and Components Location
Components 1. Front seat belt pretensioner / EFD system 2. Height adjuster 3. Second row seat belt 4. Third row seat belt ...

Components and Components Location
Component Location 1. Overdrive Clutch (OD/C) 2. One way Clutch (OWC) 3. Low & Reverse Brake (LR/B) 4. Underdrive Brake (UD/B) 5. 26 Brake(26/B) 6. 35R Clutch (35R/C) 7. Damper Clutch (D/C) ...

Inside Rear View Repair procedures
Replacement [Manual Mirror] • Put on gloves to protect your hands. 1. Loosen the inside rear view mirror mounting screw (C). 2. Push the inside rear view mirror base (B) up to remove the inside rear ...