Hyundai Santa Fe (DM): Dynamic Damper. Components and Components Location - Driveshaft Assembly - Driveshaft and axleHyundai Santa Fe (DM): Dynamic Damper. Components and Components Location

Components

1. BJ assembly
2. BJ circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Retainer ring
12. TJ housing
13. Housing circlip


TJ Joint. Repair procedures
Removal • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new one. 1. Remove the Front Driveshaft. 2. ...

Dynamic Damper. Repair procedures
Removal 1. Remove the front driveshaft. 2. Remove the TJ joint assembly. 3. Remove the remove the both side of band (B) of the dynamic damper (A). 4. Fix the driveshaft (A) with a vice (B) as illustrated. ...

See also:

Non-operational conditions of rear parking assist system
The rear parking assist system may not operate properly when: 1. Moisture is frozen to the sensor. (It will operate normally when the moisture has been cleared.) 2. The sensor is covered with foreign matter, ...

Side curtain
To use the side curtain: 1. Lift the curtain by the hook (1). 2. Hang the curtain on both sides of the hook. ...

Torque Converter Control Solenoid Valve (T/CON_VFS). Schematic Diagrams
Circuit Diagram ...