Hyundai Santa Fe: Engine Mechanical System
SS-A Solenoid Valve(ON/OFF). Repair procedures ATF Warmer. Repair procedures SRS Control Module (SRSCM). Repair procedures
General Service Information Protection Of The Vehicle Always be sure to cover fenders, seats, and floor areas before starting work. The support rod must be inserted into the hole near the edge of the hood ...
General Service InformationSee also:
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Removal 1. Drain the coolant. 2. Remove the air cleaner assembly and air duct. 3. Remove the battery and battery tray. 4. Remove the under cover(A). Tightening torque : 7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, ...
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. 4. Loosen the bolts ...
