Hyundai Santa Fe (DM): Engine Room Under Cover. Repair procedures - Engine And Transmission Assembly - Engine Mechanical SystemHyundai Santa Fe (DM): Engine Room Under Cover. Repair procedures

Removal and Installation

1.
Unfasten the fasteners (A) and bolts (B) then remove the engine room under cover (C).

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

2.
Remove the engine room side cover(A).

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

[RH]

[LH]

3.
Install in the reverse order of removal.

Engine Room Under Cover. Components and Components Location
Components 1. Under Cover 2. Side Cover (RH) 3. Side Cover (LH) ...

Engine Mounting. Components and Components Location
Components 1. Transaxle mounting bracket 2. Roll rod bracket 3. Engine mounting bracket 4. Engine mounting support bracket ...

See also:

Mirrors
Inside rearview mirror Adjust the rearview mirror so that the center view through the rear window is seen. Make this adjustment before you start driving. WARNING - Rear visibility Do not place objects ...

Emergency Fastening Device (EFD). Description and Operation
Description The Emergency Fastening Device (EFD) operates as well as the belt pretensioner at the same time, if it gets into its deploy condition after a collision. It is located near the anchor on the ...

ETC (Electronic Throttle Control) System. Description and Operation
Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cable, an Accelerator ...