Hyundai Santa Fe (DM): ESC Control Module. Repair procedures
Removal
1. |
Turn the ignition switch OFF.
|
2. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
3. |
Pull up the lock of the HECU connector (A) and then disconnect
the connector.
|
4. |
Disconnect the brake tubes from the HECU by unlocking the nuts
counterclockwise with a spanner.
|
5. |
Loosen the HECU bracket nuts (A) and then remove HECU and bracket.
|
6. |
Remove the bolts and then remove the bracket from HECU.
|
Installation
1. |
Installation is the reverse of removal.
|
2. |
Tighten the HECU mounting bolts and nuts to the specified torque.
|
3. |
After installation, bleed the
|
ESC Control Module. Components and Components Location
Components 1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module (HECU) 8. Bracket ...Front Wheel Speed Sensor. Components and Components Location
Components 1. Front wheel speed sensor 2. Front wheel speed sensor connector ...See also:
When Active ECO is activated
The engine noise may get louder. The vehicle speed may slightly be reduced. The air conditioner performance may be affected. ...
Immobilizer system
Your vehicle is equipped with an electronic engine immobilizer system to reduce the risk of unauthorized vehicle use. Your immobilizer system is comprised of a small transponder in the ignition key and ...
Front Door Window Glass. Components and Components Location
Component Location 1. Front door window glass ...