Hyundai Santa Fe (DM): Filler-Neck Assembly. Repair procedures
Removal
| 1. |
Lift the vehicle.
|
| 2. |
Disconnect the fuel filler hose (A).
|
| 3. |
Disconnect the ventilation tube quick-connector ( B).
|
| 4. |
Open the fuel filler door and unfasten the filler-neck assembly
mounting screw (A).
|
| 5. |
Remove the rear-LH wheel, tire and the inner wheel house.
|
| 6. |
Remove the filler-neck assembly from the vehicle after removing
the bracket mounting nut (A).
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Line. Repair procedures
Removal 1. Turn the ignition switch OFF, and then remove battery (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) ...
Accelerator Pedal. Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (C), the bolt (B) and ...
See also:
35R Clutch Control Solenoid Valve(35R/C_VFS). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Changing the engine oil and filter
Have engine oil and filter changed by an authorized HYUNDAI dealer according to the Maintenance Schedule at the beginning of this section. CALIFORNIA PROPOSITION 65 WARNING Engine oil contains chemicals ...
CVVT Oil Control Valve (OCV). Schematic Diagrams
Circuit Diagram ...
