Hyundai Santa Fe (DM): Front Bumper Cover. Repair procedures - Front Bumper - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Bumper Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Loosen the radiator upper cover mounting bolts and clips.
2.
Loosen the front bumper lower mounting clips.
3.
After loosening the front bumper side's mounting screw, then disconnect the side's.
4.
Disconnect the fog lamp connector (A).
5.
Remove the front bumper cover (A).
6.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Front Bumper Cover. Components and Components Location
Component Location 1. Front bumper cover ...

Radiator Grill. Components and Components Location
Component Location 1. Radiator grill ...

See also:

Components and Components Location
Components 2WD 1. Rear upper arm 2. Rear stabilizer bar 3. Rear lower arm 4. Rear assist arm 5. Rear shock absorber 6. Rear cross member 7. Trailing arm 4WD 1. Rear assist arm 2. Rear cross member 3. Rear ...

Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. 1. ...

Rear Wheel Speed Sensor. Repair procedures
Removal 4WD only 1. Remove the rear wheel and tire. Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft) 2. Remove the rear wheel speed sensor mounting bolt (A). Tightening torque: ...