Hyundai Santa Fe (DM): Front Door Belt Inside Weatherstrip. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Door Belt Inside Weatherstrip. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Front Door / Front Door Belt Inside Weatherstrip. Repair procedures

Replacement

1.
Remove the front door trim.
2.
Remove the front door belt inside weatherstrip (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Front Door Latch. Repair procedures
Replacement 1. Remove the front door module. 2. Remove the front door outside handle base (A) by pushing in the lock pins located in the back. 3. Open the front door outside handle cable cap (A). 4. Remove ...

Front Door Side Weatherstrip. Repair procedures
Replacement 1. Loosen the front door checker (B) mounting bolt. Tightening torque : 19.6 ~ 29.4 N.m (2.0 ~ 3.0 kgf.m,14.5 ~ 21.7 lb-ft) 2. Detach the clips, then remove the front door side weatherstrip ...

See also:

Input Speed Sensor. Schematic Diagrams
Circuit Diagram ...

Rear Door Latch. Components and Components Location
Component Location 1. Rear door latch ...

Rear Upper Arm. Repair procedures
Removal 1. Remove the rear wheel and tire (A) from rear hub . Tightening torque : 88.2 ~ 107.8 N.m (9.0 ~ 11.0 kgf.m, 65.0 ~ 79.5 lb-ft) Be careful not to damage to the hub bolts when removing the rear ...