Hyundai Santa Fe (DM): Front Door Latch. Repair procedures - Front Door - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Door Latch. Repair procedures

Replacement

1.
Remove the front door module.
2.
Remove the front door outside handle base (A) by pushing in the lock pins located in the back.

3.
Open the front door outside handle cable cap (A).
4.
Remove the front door outside handle cable (B).
5.
Disconnect the front door latch connector (B).
6.
Remove the front door latch assembly (A) by pulling it.
7.
Remove the front door inside handle cable (A) by pulling it.
8.
Install in the reverse order of removal.
•
Make sure the connector is connected properly.
•
Make sure the door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.

Front Door Latch. Components and Components Location
Component Location 1. Front door latch ...

Front Door Belt Inside Weatherstrip. Repair procedures
Replacement 1. Remove the front door trim. 2. Remove the front door belt inside weatherstrip (A). 3. Install in the reverse order of removal. • Replace any damaged clips. ...

See also:

Auto defogging system
Auto defogging reduces the probability of fogging up the inside of the windshield by automatically sensing the moisture of inside the windshield. The auto defogging system operates when the heater or ...

Repair procedures
Adjustment Description The friction material inside the coupling will degrade over time. Therefore, corresponding compensation values must be referenced and entered after replacing the controller or the ...

Special Service Tools
Special Service Tools Tool(Number and Name) Illustration Use 09495-33000 Puller Removal of spider assembly from a drive shaft. 09568-4A000 Ball joint puller Remove the ball joint 09495-3K000 Band installer ...