Hyundai Santa Fe (DM): Front Fog Lamps. Repair procedures
Inspection
| 1. |
With the fog lamp switch in each position, make sure
that continuity exists between the terminals below. If continuity is
not as specified, replace the multifunction switch.
https://eastline-garage.ru/interior-re-covering/toyota/land_cruiser_prado/
|
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front bumper.
|
| 3. |
Remove the front fog lamp assembly (A) after loosening
the mounting screws (4EA).
|
| 4. |
Remove the front fog lamp (A) by turning in the counter
clock-wise direction after disconnecting the connector.
|
Installation
| 1. |
Install the front fog lamp bulb.
|
| 2. |
Connect the front fog lamp connector.
|
| 3. |
Install the front bumper.
|
Rheostat. Repair procedures
Inspection 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad side cover. 3. Remove the lower crash pad switch assembly (A) after loosening the screws (3EA). 4. Remove the rheostat ...
License Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A). Installation ...
See also:
Hazardous driving conditions
When hazardous driving conditions are encountered such as water, snow, ice, mud, sand, or similar hazards, follow these suggestions: Drive cautiously and allow extra distance for braking. Avoid sudden ...
Head Lamps. Repair procedures
Inspection 1. Check-points upon head lamp failure (HID) (1) Check the battery voltage. (Low beam will be on when the battery voltage above 9V.) (2) Check the fuse and relay. (3) Check the polarity of ballast. ...
Tire maintenance
In addition to proper inflation, correct wheel alignment helps to decrease tire wear. If you find a tire is worn unevenly, have your dealer check the wheel alignment. When you have new tires installed, ...
