Hyundai Santa Fe (DM): Front Impact Sensor (FIS). Repair procedures - SRSCM - RestraintHyundai Santa Fe (DM): Front Impact Sensor (FIS). Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Restraint / SRSCM / Front Impact Sensor (FIS). Repair procedures

Removal

•
Removal of the airbag must be performed according to the precautions/ procedures described previously.
•
Before disconnecting the front impact sensor connector, disconnect the front airbag connector(s).
•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Disconnect the battery negative cable, and wait for at least three minutes before beginning work.
2.
Remove the front impact sensor mounting bolt (A).
Подробная информация замена масла в коробке ауди q5 на сайте.

3.
Disconnect the front impact sensor connector.

Installation

•
Do not turn the ignition switch ON and do not connect the battery cable while replacing the front impact sensor.
1.
Install the new front impact sensor.
2.
Tighten the front impact sensor mounting bolt.
Tightening torque :
6.8 ~ 9.2 N.m (0.7 ~ 0.94 kgf.m, 5.0 ~ 6.8 lb-ft)
3.
Connect the front impact sensor connector.
4.
Install the radiator upper cover and air duct.
5.
Reconnect the battery negative cable.
6.
After installing the Front Impact Sensor, confirm proper system operation:
A.
Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

Front Impact Sensor (FIS). Components and Components Location
Components ...

Side Impact Sensor (SIS). Description and Operation
Description Side Impact Sensor (SIS) system consists of two Pressure Side Impact Sensor (P-SIS) which are installed at each center of the front door module (LH and RH) and two SIS which are installed at ...

See also:

Gasoline containing alcohol and methanol
Gasohol, a mixture of gasoline and ethanol (also known as grain alcohol), and gasoline or gasohol containing methanol (also known as wood alcohol) are being marketed along with or instead of leaded or ...

Emergency Fastening Device (EFD). Description and Operation
Description The Emergency Fastening Device (EFD) operates as well as the belt pretensioner at the same time, if it gets into its deploy condition after a collision. It is located near the anchor on the ...

Side Body. Body Repair
Side Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Side Body B * These dimensions indicated in this figure are actual-measurement dimensions. ...