Hyundai Santa Fe (DM): Front Seat Assembly. Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Seat Assembly. Repair procedures

Replacement

1.
Remove the front seat track mounting cover.
2.
After loosening the mounting bolts, remove the front seat assembly (A).
Tightening torque :
34.3 ~ 53.9 N.m (3.5 ~ 5.5 kgf.m, 25.3 ~ 39.8 lb-ft)

3.
Disconnect the seat buckle connector (A), seat warmer & power seat connector (B), SAB connector(C), PODS connector (D).
[Driver's]

[Passenger's]
4.
Install in the reverse order of removal.
SEAT MOUNTING BOLT INSTALLATION PROCEDURE
•
Set the seat into the most rearward position. Check that each slide is locked, and then tighten the front mounting bolt temporarily.
•
Set the seat into most forward position. Check that each slide is locked, and then Tighten the rear mounting bolt completely.
•
Set the seat into the most rearward position. Check the front mounting bolt completely.
•
Check that the seat operates to and fro smoothy and the locking portion locks properly.

Front Seat Assembly. Components and Components Location
Component Location 1. Front seat assembly ...

Front Seat Shield Outer Cover. Components and Components Location
Component Location 1. Front seat shield outer cover ...

See also:

Air conditioning
Press the A/C button to turn the air conditioning system on (indicator light will illuminate). Press the button again to turn the air conditioning system off. ...

General Information. Troubleshooting
Troubleshooting Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywheel Replace the crankshaft and ...

Weight of the trailer
What is the maximum safe weight of a trailer? It should never weigh more than the maximum trailer weight with trailer brakes. But even that can be too heavy. It depends on how you plan to use your trailer. ...