Hyundai Santa Fe (DM): Front Seat Belt Pretensioner. Repair procedures - Front Seat Belt - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Seat Belt Pretensioner. Repair procedures

Replacement

•
When installing the belt, make sure not to damage the pretensioner.
1.
Remove the center pillar upper trim.
2.
After loosening the mounting bolt, then remove the front seat belt upper anchor (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
Loosen the mounting bolts, and remove the front seat belt pretensioner (B).
4.
Disconnect the pretensioner connector lock pin, and remove the front seat belt pretensioner connector (A).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

5.
Install in the reverse order of removal.
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.

Front Seat Belt Pretensioner. Components and Components Location
Component Location 1. Front seat belt pretensioner ...

Height Adjust. Components and Components Location
Component Location 1. Height adjust ...

See also:

Components and Components Location
Components 1. Hands free call switch 2. Mic 3. Front left speaker 4. Front right speaker 5. Audio head unit (hands free control) ※ There is no hands free jack. This system supports Bluetooth(wireless ...

Components and Components Location
Components Location 1. Purge Control Solenoid Valve (PCSV) 2. Vapor line 3. Fuel tank air filter 4. Canister Close Valve (CCV) 5. Canister 6. Fuel Tank Pressure Sensor (FTPS) ...

If the engine overheats
If your temperature gauge indicates overheating, you experience a loss of power, or hear loud pinging or knocking, the engine is probably too hot. If this happens, you should: 1. Pull off the road and ...