Hyundai Santa Fe (DM): Front Seat Cushion Cover. Repair procedures - Front Seat - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Seat Cushion Cover. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the front seat shield inner cover.
2.
Remove the front seat shield outer cover.
3.
Remove the front seat lower protector (A).
4.
Disconnect the connectors (A).
5.
Push the protecter (A), and then front seat cushion cover (C) from the front seat cushion frame (B).
6.
To remove the air ventilation seat cushion duct (A), widen the both sides of the clips (B) as the direction of the arrow and then pull down the air ventilation seat cushion duct.

7.
Remove the front seat cushion cover (A) from the front seat cushion frame.
8.
Remove the velcro tape (A).
9.
After removing the hog-ring clips (A) on the front of seat cushion and remove the front seat cushion cover (B).
10.
Install in the reverse order of removal.
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool [C (09880-4F000)].


Front Seat Cushion Cover. Components and Components Location
Component Location 1. Front seat cushion cover ...

Front Seat Frame Assembly. Components and Components Location
Component Location 1. Front seat back frame assembly 2. Front seat cushion frame assembly ...

See also:

Gasoline containing alcohol and methanol
Gasohol, a mixture of gasoline and ethanol (also known as grain alcohol), and gasoline or gasohol containing methanol (also known as wood alcohol) are being marketed along with or instead of leaded or ...

Rear Hub - Carrier. Components and Components Location
Components 1. Rear carrier assembly 2. Parking brake assembly 3. Rear hub assembly 4. Rear brake disc ...

Heated Oxygen Sensor (HO2S). Repair procedures
Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 4 and 5 [B1/S1]. 4. Measure resistance between the HO2S terminals 3 and 4 ...