Hyundai Santa Fe (DM): Front Suspension System
All Wheel Drive (AWD) LOCK Indicator Light Towing service DBC Switch. Repair procedures
Troubleshooting Symptom Possible cause Remedy Hard steering Improper front wheel alignment Excessive turning resistance of lower arm ball joint Low tire pressure No power assist Correct Replace Adjust ...
Troubleshooting
Components Location 1. Front axle 2. Front lower arm 3. Drive shaft 4. Sub frame 5. Stabilizer bar 6. Steering gearbox 7. Stabilizer link 8. Front strut assembly ...
Components and Components LocationSee also:
This indicator light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When you select AWD Lock ...
If emergency towing is necessary, we recommend having it done by an authorized HYUNDAI dealer or a commercial tow-truck service. Proper lifting and towing procedures are necessary to prevent damage to ...
Inspection 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the crash pad lower panel. 3. Remove the crash pad side switch assembly (A) after loosening the screws. 4. ...
