Hyundai Santa Fe (DM): Front Wheel Guard. Repair procedures - Body Side Molding - Body (Interior and Exterior)Hyundai Santa Fe (DM): Front Wheel Guard. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Remove the front tire.
2.
After loosening the mounting clips and screws, then remove the front wheel guard (A).
3.
Install in the reverse order of removal.
•
Replace any damaged clips.

Door Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

Rear Wheel Guard. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

See also:

Water Temperature Control Assembly. Repair procedures
Removal 1. Disconnect the battery negative terminal. 2. Loosen the drain plug and drain the engine coolant. 3. Remove the radiator upper hose and lower hose. 4. Disconnect the connectors and then remove ...

Rear Driveshaft. Components and Components Location
Components 1. Tone wheel 2. BJ joint 3. BJ boot 4. BJ boot big part band 5. BJ boot small part band 6. Shaft 7. TJ boot small part band 8. TJ boot big part band 9. TJ boot 10. Snap ring 11. Circlip 12. ...

Forward and rearward
To move the seat forward or rearward: 1. Pull the seat slide adjustment lever up and hold it. 2. Slide the seat to the position you desire. 3. Release the lever and make sure the seat is locked in place. ...