Hyundai Santa Fe (DM): Front Wheel Repair procedures - Transfer Assembly - 4 Wheel Drive (4WD) SystemHyundai Santa Fe (DM): Front Wheel Repair procedures

Removal

1.
Remove the driveshaft and axle.
2.
Remove the propeller shaft (A).
Tightening torque :
49.0~68.6N.m (5.0~7.0kgf.m, 36.2~50.6lb-ft)

3.
Loosen the transfer upper & lower mounting bolts. (transfer side → transaxle side)
4.
Loosen the transfer lower mounting blot. (transaxle side → transfer side)

Installation

1.
Install in the reverse order of removal.
1.
Be careful not to damage the O-ring (A). If the O-ring is damaged, replace with a new one.
2.
Smear and cover splines (B) with molybdenum type high pressure grease.
TECHLUBE MEGAMAX - ALPHA OR EQUIVALENT

3.
Install the propeller shaft to be near runout marking (Transfer assembly 1ea, propeller shaft 1ea) each other.

Front Wheel Components and Components Location
Components Location 1.Under cover 2. Transaxle Assembly 3. Transfer assembly 4. Propeller shaft 5. Coupling assembly ...

Oil Seal. Repair procedures
Replacement [Right side] 1. Remove the driveshaft assembly. (RH side) 2. Remove the dust cover (A). 3. Remove the oil seal (A, B). 4. Install the oil seal with special service tools. • Apply lithium ...

See also:

Troubleshooting
Troubleshooting Symptom Suspect Area Remedy (Refer to page) Water leaks from panorama sunroof Deteriorated roof lid weatherstrip Replace Excessive roof lid-to-body clearance and improperly fitted weatherstrip ...

Certification label
The certification label is located on the driver's door sill at the center pillar. This label shows the maximum allowable weight of the fully loaded vehicle. This is called the GVWR (Gross Vehicle ...

Light bulbs
WARNING - Working on the lights Prior to working on the light, firmly apply the parking brake, ensure that the ignition switch is turned to the “LOCK”position and turn off the lights to avoid sudden ...