Hyundai Santa Fe (DM): Front Wiper Motor. Repair procedures
Removal
1. |
Loosen the windshield wiper arm nut after removing
a wiper cap (A).
|
2. |
Remove the windshield wiper arm and blade (B)
|
3. |
If necessary, release the wiper blade fixing clip
by pulling up and remove the wiper blade from the inside radius of wiper
arm.
|
4. |
Remove the cowl top cover.
|
5. |
Disconnect the wiper motor connector (A) from the
wiper motor & linkage assembly.
|
6. |
Remove the windshield wiper motor and linkage assembly
(A) after removing 3 bolts.
|
7. |
Hold the wiper motor crank arm and remove the upper
linkage (A) from the wiper motor crank arm.
|
8. |
Remove the lower linkage (A) from the wiper motor
crank arm.
|
9. |
Remove the crank arm (B) after loosening a nut (A).
|
10. |
Remove the bracket (A) after loosening the screws
(3EA).
|
11. |
Remove the wiper motor (A) from the tube.
|
Installation
1. |
Install the wiper motor.
|
2. |
Install the crank arm.
|
3. |
Install the lower and upper linkage to the wiper
motor crank arm.
|
4. |
Install the wiper motor and linkage assembly and
then connect the wiper motor connector.
|
5. |
Install the cowl top cover.
|
6. |
Install the windshield wiper arm and blade.
|
7. |
Install the wiper arm and blade to the specified
position.
A: Auto stop position (Blade)
|
Inspection
Speed Operation Check
1. |
Remove the connector (A) from the wiper motor.
|
2. |
Attach the positive (+) lead from the battery to
terminal 3 and the negative (-) lead to terminal 1.
|
3. |
Check that the motor operates at low or high speed
as below table.
|
Front Wiper Motor. Components and Components Location
Component Location 1. Cap 2. Nut 3. Wiper arm & blade 4. Rivet 5. Cowl top cover 6. Bolt 7. Wiper motor & linkage assembly 8. Wiper motor connector ...Front Washer Motor. Repair procedures
Inspection Front and Rear Washer Motor 1. With the washer motor connected to the reservoir tank, fill the reservoir tank with water. Before filling the reservoir tank with water, check the filter for foreign ...See also:
Roller Blind Motor. Repair procedures
Replacement 1. Refer to the inspection procedure in the panorama sunroof motor. ...
Steering Angle Sensor. Description and Operation
Description The Steering Angle Sensor (SAS) is installed in MDPS (Motor Driven Power Steering) and it sends messages to HECU through CAN communication line. The SAS is used to determine turning direction ...
Seat Heater (Non-Air Ventilation). Repair procedures
Inspection Front Seat 1. Check for continuity and measure the resistance between terminals. No. Description No. Description 1 Heater cushion + 4 Heater back + 2 NTC + 5 - 3 Ground 6 NTC - Standard value ...