Hyundai Santa Fe (DM): Fuel Line. Repair procedures - Fuel Delivery System - Engine Control/Fuel SystemHyundai Santa Fe (DM): Fuel Line. Repair procedures

Removal

1.
Turn the ignition switch OFF, and then remove battery (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”)
3.
Disconnect the low pressure fuel quick-connector (A).

4.
Disconnect the vapor hose (A) which is connected from the PCSV.

5.
Lift the vehicle.
6.
Remove the fuel tank.
(Refer to Fuel Delivery System - " Fuel Tank")
7.
Disconnect the vapor tube quick-connector (A).

8.
Open the vapor tube and low fuel line fixing clip to using driver.
9.
Release the under cover (A) after remove the mounting bolts.

10.
Disconnect the fuel & brake line protect (A) from the fixing clip.

11.
Disconnect the fuel line fixing bracket (A) to engine room low.

12.
Remove the fuel line.

Installation

1.
Install in the reverse order of removal.

Fuel Pressure Regulator. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Release the fixing hooks, and then remove the regulator cup (A). 3. Remove the fuel pressure regulator (A). Installation ...

Filler-Neck Assembly. Repair procedures
Removal 1. Lift the vehicle. 2. Disconnect the fuel filler hose (A). 3. Disconnect the ventilation tube quick-connector ( B). 4. Open the fuel filler door and unfasten the filler-neck assembly mounting ...

See also:

Injured person
A seat belt should be used when an injured person is being transported. When this is necessary, you should consult a physician for recommendations. ...

Closing the hood
1. Before closing the hood, check the following: All filler caps in engine compartment must be correctly installed. Gloves, rags or any other combustible material must be removed from the engine compartment. ...

Fuel Tank. Repair procedures
Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - “Release Residual Pressure in Fuel Line”) 2. Remove the rear seat assembly. (Refer to Body - “Rear Seat Assembly") ...