Hyundai Santa Fe (DM): Fuel Pump Motor. Repair procedures
Removal
1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
|
2. |
Disconnect the fuel sender connector (A).
|
3. |
Release the fixing hooks, and then remove the fuel sender (A).
|
4. |
Release the fixing hooks (A), and then fuel filter & motor assembly
from reservoir cup.
|
Installation
1. |
Install in the reverse order of removal.
|
Fuel Filter. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...Fuel Sender. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). Installation ...See also:
Vehicle Identification Number (VIN). Vehicle certification label. Tire specification
and pressure label
Vehicle Identification Number (VIN) The vehicle identification number (VIN) is the number used in registering your vehicle and in all legal matters pertaining to its ownership, etc. The number is punched ...
SS-A Solenoid Valve(ON/OFF). Specifications
Specifications ON/OFF Solenoid Valve(SS-A) ▷ Control type : Normal low type Control pressure kpa (kgf/cm², psi) 490.33(5.0, 71.12) Internal resistance(Ω) 10~11 ...
Jump starting procedure
✽ NOTICE If the battery is discharged, the engine can be started using a battery of another vehicle and two jumper cables. Only use jumper cables with fully insulated clamp handles. To prevent personal ...