Hyundai Santa Fe (DM): Fuel Sender. Repair procedures
Removal
| 1. |
Remove the fuel pump.
(Refer to Fuel Delivery System - “Fuel Pump”)
|
| 2. |
Disconnect the fuel sender connector (A).
|
| 3. |
Release the fixing hooks, and then remove the fuel sender (A).
|
Installation
| 1. |
Install in the reverse order of removal.
|
Fuel Pump Motor. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Disconnect the fuel sender connector (A). 3. Release the fixing hooks, and then remove the fuel sender (A). 4. Release ...
Fuel Pressure Regulator. Repair procedures
Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - “Fuel Pump”) 2. Release the fixing hooks, and then remove the regulator cup (A). 3. Remove the fuel pressure regulator (A). Installation ...
See also:
TJ Joint. Repair procedures
Removal • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a new one. 1. Remove the Front Driveshaft. 2. ...
General Information. Troubleshooting
Troubleshooting Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywheel Replace the crankshaft and ...
ATF Warmer. Description and Operation
Description The ATF warmer is mounted on the valve body cover to reduce oil viscosity friction by increasing oil temperature under cold condition, which in turn improves fuel efficiency. It is serial mounted ...
