Hyundai Santa Fe (DM): Fuel Tank Pressure Sensor (FTPS). Repair procedures
Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Measure the output voltage of the FTPS.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Remove the rear seat.
(Refer to Body - "Rear Seat Assembly")
|
3. |
Remove the fuel pump service cover (A) in the trunk.
|
4. |
Disconnect the fuel tank pressure sensor connector (A), and then
remove the fuel tank pressure sensor.
|
Installation
|
|
1. |
Install in the reverse order of removal.
|
Fuel Tank Pressure Sensor (FTPS). Schematic Diagrams
Circuit Diagram ...Injector. Description and Operation
Description Based on information from various sensors, the ECM can calculate the fuel amount to be injected. The fuel injector is a solenoid-operated valve and the fuel injection amount is controlled by ...See also:
Front Seat Frame Assembly. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...
Description and Operation
Description Limitations Of The Navigation system GPS Signal Reception State As the GPS satellite frequency is received/transmitted in straight lines, reception may not work if hiding devices are placed ...
3. Exhaust emission control system
The Exhaust Emission Control System is a highly effective system which controls exhaust emissions while maintaining good vehicle performance. Vehicle modifications This vehicle should not be modified. ...