Hyundai Santa Fe (DM): General Information - Body Dimensions - Body (Interior and Exterior)Hyundai Santa Fe (DM): General Information

General

1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual.

Measurement Method

Projected Dimensions
1.
These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions used for body alterations.
2.
If the length of the tracking gauge probes is adjustable, make the measurement by lengthening one probe by the amount equivalent to the difference in height of the two surfaces.
Actual-Measurement Dimensions
1.
These dimensions indicate the actual linear distance between measurement points, and are the reference dimensions for use if a tracking gauge is used for measurement.
2.
Measure by first adjusting both probes to the same length (A=A').
Check the probes and gauge itself to make sure there is no free play.

Measurement Point
1.
Measurements should be taken at the hole center.

Body Dimensions
...

Front Body. Body Repair
Front Body A * These dimensions indicated in this figure are actual-measurement dimensions. [ Unit : mm (inch) ] Front Body B * These dimensions indicated in this figure are actual-measurement dimensions. ...

See also:

Seats
Front seat (1) Forward and rearward (2) Seatback angle (3) Seat cushion angle (4) Seat cushion height (5) Seat cushion length* (6) Lumbar support (Driver’s seat)* (7) Seat warmer* (8) Air ventilation ...

Manual climate control system
1. MAX A/C (Max air conditioning) button 2. A/C (Air conditioning) button 3. Mode selection buttons 4. Fan speed control knob 5. Rear window defroster button 6. Front windshield defrost button 7. Temperature ...

Cowl Side Trim. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...