Hyundai Santa Fe (DM): General Information. Repair procedures - General Information - Engine Mechanical SystemHyundai Santa Fe (DM): General Information. Repair procedures

Compression Pressure Inspection

If the there is lack of power, excessive oil consumption or poor fuel economy, measure the compression pressure.
1.
Warm up and stop engine.
Allow the engine to warm up to normal operating temperature.
2.
Disconnect the injector extension connector (A) and ignition coil connectors (B).
Транспортная компания. На корпоратив аренда автобуса с водителем на 35 мест Москва недорого.

3.
Remove ignition coils (A).

4.
Remove spark plugs.
Using a 16mm plug wrench, remove the 4 spark plugs.
5.
Check cylinder compression pressure.
(1)
Insert a compression gauge into the spark plug hole.

(2)
Fully open the throttle.
(3)
While cranking the engine, measure the compression pressure.
Always use a fully charged battery to obtain engine speed of 200 rpm or more.
(4)
Repeat steps (1) through (3) for each cylinder.
This measurement must be done in as short a time as possible.

Compression pressure :
1,324 kPa (13.5 kgf/cm², 192 psi) / 200 ~ 250 rpm
Minimum pressure :
1,177 kPa (12.0 kgf/cm², 171 psi)
Difference between each cylinder :
100 kPa (1.0 kgf/cm², 15 psi) or less

(5)
If the cylinder compression in 1 or more cylinders is low, pour a small amount of engine oil into the cylinder through the spark plug hole and repeat steps (1) through (3) for cylinders with low compression.
A.
If adding oil helps the compression, it is likely that the piston rings and/or cylinder bore are worn or damaged.
B.
If pressure stays low, a valve may be sticking or seating is improper, or there may be leakage past the gasket.
6.
Reinstall spark plugs.
7.
Install ignition coils.
8.
Connect the injector extension connector and ignition coil connectors.
9.
Some DTC's may exist after the inspection test and may need to be manually cleared with GDS.

Specifications - Revised
Specifications Description Specifications Limit General Type In-line, DOHC   Number of cylinders 4   Bore 88 mm (3.464 in)   Stroke 97 mm (3.819 in)   Total displacement 2359cc ...

General Information. Troubleshooting
Troubleshooting Symption Suspect area Remedy Engine misfire with abnormal internal lower engine noises. Worn crankshaft bearings Loose or out of specification engine flywheel Replace the crankshaft and ...

See also:

Cruise control switch
CRUISE : Turns cruise control system on or off. CANCEL: Cancels cruise control operation. RES+: Resumes or increases cruise control speed. SET-: Sets or decreases cruise control speed. ...

Fuel requirements
Your new vehicle is designed to use only unleaded fuel having a pump octane number ((R+M)/2) of 87 (Research Octane Number 91) or higher. Your new vehicle is designed to obtain maximum performance with ...

Driver Airbag (DAB) Module and Clock Spring. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (Ø5mm) into the guide hole ...