Hyundai Santa Fe (DM): Glove Box Housing. Repair procedures - Crash Pad - Body (Interior and Exterior)Hyundai Santa Fe (DM): Glove Box Housing. Repair procedures

Replacement

•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Disconnect the stopper (B) from the glove box (A).
2.
Disconnect the air damper (A) from the glove box (B).
3.
Disconnect the pins (A) and then remove the glove box (B).
4.
Remove the gear boots (B) and gear knob (A).
5.
Using a screwdriver or remover, remove the console upper cover (A).
6.
Disconnect the connectors (A).
7.
Using a screwdriver or remover, remove the front console garnish (A).
8.
Using a screwdriver or remover, remove the crash pad side cover [RH] (A).
9.
After loosening the mounting screws, then remove the crash pad garnish [RH] (A).
10.
After loosening the mounting screws, then remove the crash pad under cover [RH] (A).
11.
Remove the glove box hose cover (A) by sliding it upward.
12.
Remove the glove box hose (B) by sliding it upward.
13.
After loosening the mounting screws, then remove the glove box housing (A).
14.
Disconnect the glove box lamp connector (A) and glove box lamp switch connector (B).
15.
Install in the reverse order of removal.
•
Make sure the connector are connected in properly.
•
Replace any damaged clips.

Glove Box Housing. Components and Components Location
Component Location 1. Glove box housing ...

Steering Column Shroud Panel. Components and Components Location
Component Location 1. Steering column shroud lower panel 2. Steering column shroud upper panel ...

See also:

Repair procedures
Replacement [Removal] • Put on gloves to protect your hands. • Use seat covers to avoid damaging any surfaces. 1. Remove the rear pillar trim. 2. Loosen the quarter fixed glass (A) mounting nuts. Tightening ...

Fender Garnish. Repair procedures
Replacement • Put on gloves to protect your hands. • When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage. • ...

To remove the cargo security screen
1. Push in the guide pin. 2. While pushing the lever, pull out the cargo security screen. 3. Open the luggage tray and keep the cargo security screen in the tray. ...