Hyundai Santa Fe (DM): Headrest - Front seat adjustment - Power - Seats - Safety features of your vehicleHyundai Santa Fe (DM): Headrest

The driver's and front passenger's seats are equipped with a headrest for the

The driver's and front passenger's seats are equipped with a headrest for the occupant's safety and comfort.

The headrest not only provides comfort for the driver and front passenger, but also helps to protect the head and neck in the event of a collision.

WARNING - Headrest adjustment

  • For maximum effectiveness in case of an accident, the headrest should be adjusted so the middle of the headrest is at the same height as the center of gravity of an occupant's head. Generally, the center of gravity of most people's head is similar with the height of the top of their eyes. Also adjust the headrest as close to your head as possible. For this reason, the use of a cushion that holds the body away from the seatback is not recommended.
  • Do not operate the vehicle with the headrests removed. Severe injury to an occupant may occur in the event of an accident. Headrests may provide protection against severe neck injuries when properly adjusted.
  • Do not adjust the headrest position of the driver's seat while the vehicle is in motion.

Forward and backward adjustment

Forward and backward adjustment

The headrest may be adjusted forward to 4 different positions by pulling the headrest forward to the desired detent. To adjust the headrest to backwards position, press and hold the release button (1), and adjust position of the headrest. Adjust the headrest so that it properly supports the head and neck.

Adjusting the height up and down

Adjusting the height up and down

To raise the headrest :

1. Pull it up to the desired position (1).

To lower the headrest :

1. Push and hold the release button (2) on the headrest support
2. Lower the headrest to the desired position (3).

Removal and installation

Removal and installation

To remove the headrest :

1. Raise it as far as it can go then press the release button with the slim tool (1) while pulling the headrest up (2).

To reinstall the headrest :

1. Put the headrest poles (3) into the holes.
2. Adjust it to the appropriate height.

Lumbar support (for driver’s seat)
The lumbar support can be adjusted by pressing the switch. 1. Press the front portion (1) of the switch to increase support, or the rear portion (2) of the switch, to decrease support. 2. Release the ...

Seat warmer
The seat warmer is provided to warm the front seats during cold weather. With the ignition switch in the ON position, push either of the switches to warm the driver's seat or the front passenger's ...

See also:

SS-B Solenoid Valve(ON/OFF). Description and Operation
Description SS-B solenoid valve is attached to the valve body and is an on/off solenoid valve that is used to change gears. SS-B Solenoid valve(ON/OFF) is installed at valve body. ...

Crankshaft Damper Pulley. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the passenger engine room side cover. 3. Remove the passenger front tire. 4. Remove the crankshaft damper pulley(A). Tightening torque : 166.6 ...

User Settings Mode
Description On this mode, you can change setting of the doors, lamps, and so on. Door Auto Door Lock (if equipped) • Off: The auto door lock operation will be deactivated. • Speed: All doors will be ...