Hyundai Santa Fe (DM): Heated Oxygen Sensor (HO2S). Repair procedures
Inspection
1. |
Turn the ignition switch OFF.
|
2. |
Disconnect the HO2S connector.
|
3. |
Measure resistance between the HO2S terminals 4 and 5 [B1/S1].
|
4. |
Measure resistance between the HO2S terminals 3 and 4 [B1/S2].
|
5. |
Check that the resistance is within the specification.
|
https://arsenev.dostavka-byketov.ru доставка цветов Арсеньев.
Removal
1. |
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
|
2. |
Disconnect the connector (A), and then remove the sensor (B).
[Bank 1 / Sensor 1]
[Bank 1 / Sensor 2]
|
Installation
|
|
1. |
Install in the reverse order of removal.
|
Heated Oxygen Sensor (HO2S). Schematic Diagrams
Circuit Diagram ...Rail Pressure Sensor (RPS). Description and Operation
Description Rail Pressure Sensor (RPS) is installed on the delivery pipe and measures the instantaneous fuel pressure in the delivery pipe. The sensing element (Semiconductor element) built in the sensor ...See also:
Smart Key Diagnostic. Repair procedures
Inspection Self Diagnosis With Scan Tool It will be able to diagnose defects of SMART KEY system with GDS quickly. GDS can operates actuator forcefully, input/output value monitoring and self diagnosis. ...
Safety chains
You should always attach chains between your vehicle and your trailer. Cross the safety chains under the tongue of the trailer so that the tongue will not drop to the road if it becomes separated from ...
Yaw-rate and G Sensor. Repair procedures
Removal 1. Remove the ignition key from the vehicle. 2. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 3. Remove the floor console. 4. Loosen the bolts ...