Hyundai Santa Fe (DM): High Mounted Stop Lamp. Repair procedures
Removal
High Mounted Stop Lamp |
1. |
Disconnect the negative (-) battery terminal.
|
2. |
Remove the rear spoiler.
|
3. |
Remove the high mounted stop lamp assembly (A) after
loosening screws (4EA).
|
Installation
1. |
Install the high mounted stop lamp.
|
2. |
Install the rear spoiler.
|
3. |
Connect the negative (-) battery terminal.
|
License Lamps. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the license lamp lens (A) from the panel after loosening a screw. 3. Replace the bulb (B) after removing the license lamp (A). Installation ...Luggage Room Lamp. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the luggage room lamp lens (A) with a flat-tip screwdriver after loosening the screws (2EA). 3. Remove the luggage room lamp bulb (A). ...See also:
Power Seat Motor. Repair procedures
Inspection Power Seat Motor 1. Disconnect the connectors for each motor. A : Slide motor B : Front height motor C : Rear height motor D : Lumbar support motor (Horizontal) E : Lumbar support motor (Vertical) ...
Door Ajar Warning Light
This warning light illuminates: When a door is not closed securely. ...
Low Tire Pressure Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It illuminates for approximately 3 seconds and then goes off. When one or more of your ...