Hyundai Santa Fe (DM): Hood Latch Release Handle. Repair procedures - Hood - Body (Interior and Exterior)Hyundai Santa Fe (DM): Hood Latch Release Handle. Repair procedures

Hyundai Santa Fe DM 2013-2018 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle. Repair procedures

Replacement

1.
Using a screwdriver or remover, remove the hood release handle (A).
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.
Install in the reverse order of removal.
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.

Hood Latch Release Handle. Components and Components Location
Component Location 1. Hood latch release handle ...

Hood Latch. Components and Components Location
Component Location 1. Hood upper latch assembly 2. Hood lower latch assembly ...

See also:

Special Service Tools
Special Service Tools Tool(Number and Name) Illustration Use 09495-33000 Puller Removal of spider assembly from a drive shaft. 09568-4A000 Ball joint puller Remove the ball joint 09495-3K000 Band installer ...

Repair procedures
On-vehicle Inpection • First of all, check for DTCs. If a DTC is present, perform troubleshooting in accordance with the procedure for that DTC. (Refer to DTC guide) • Check that the battery cables ...

Driver Airbag (DAB) Module and Clock Spring. Repair procedures
Removal 1. Disconnect the battery negative cable and wait for at least three minutes before beginning work. 2. Remove the driver airbag module by putting in a flat tool (Ø5mm) into the guide hole ...