Hyundai Santa Fe (DM): Hood Latch. Repair procedures - Hood - Body (Interior and Exterior)Hyundai Santa Fe (DM): Hood Latch. Repair procedures

Replacement

[Hood upper latch assembly]
1.
After loosening the mounting bolts, then remove the hood upper latch assembly (A).
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

2.
Install in the reverse order of removal.
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.
[Hood lower latch assembly]
1.
Remove the front bumper cover.
2.
Remove the hood lower latch assembly (A) mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Disconnect the hood lower latch connector (A).
4.
Disconnect the hood latch release handle cable (B) and remove the hood lower latch assembly (A).

5.
Install in the reverse order of removal.
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.

Hood Latch. Components and Components Location
Component Location 1. Hood upper latch assembly 2. Hood lower latch assembly ...

Tail Gate
...

See also:

Front Door Module. Repair procedures
Replacement 1. Remove the front door window glass. 2. Remove the front door outside handle. 3. Disconnect the front door main connector (A). 4. Loosen the front door outside handle base mounting bolt (A). ...

CVVT Oil Control Valve (OCV). Schematic Diagrams
Circuit Diagram ...

Line Pressure Control Solenoid Valve. Specifications
Specifications Direct control VFS[LINE Pressure] ▷ Control type : Normal high type Control Pressure kpa (kgf/cm², psi) 500.14~9.81 (5.1~0.1,72.54~1.42) Current value(mA) 50~850 Internal resistance(Ω) ...