Hyundai Santa Fe DM 2013-2018 Service Manual
Service manual for Third generation (DM) Hyundai Santa Fe. Capping off what has been an epic march up the rankings for Hyundai, the redesigned 2013 Santa Fe adopts the company's "fluidic sculpture" design with favorable results. For the first time, Hyundai is also offering two models of this crossover. The Santa Fe GLS and Limited now feature a third row of seats, increasing the passenger count to seven (or six in the case of the Limited) and effectively replacing the outgoing Hyundai Veracruz.
- General Information
- Important Safety Notice
- Identification Numbers
- Warning And Caution Labels
- Lift And Support Points
- Towing
- General Tightening Torque Table
- Basic Service Symbols
- General Service Information
- Engine Mechanical System
- General Information
- Engine And Transmission Assembly
- Timing System
- Cylinder Head Assembly
- Cylinder Block
- Cooling System
- Lubrication System
- Intake And Exhaust System
- Engine Electrical System
- Emission Control System
- General Information
- Crankcase Emission Control System
- Evaporative Emission Control System
- Exhaust Emission Control System
- Engine Control/Fuel System
- Automatic Transaxle System
- General Information
- Automatic Transaxle System
- Hydraulic System
- Clutch & Brake
- Automatic Transaxle Control System
- 4 Wheel Drive (4WD) System
- Driveshaft and axle
- General Information
- Front Axle Assembly
- Driveshaft Assembly
- Rear Axle Assembly
- Rear Driveshaft Assembly
- Propeller Shaft Assembly
- Differential Carrier Assembly
- Suspension System
- General Information
- Front Suspension System
- Rear Suspension System
- Tires/Wheels
- Tire Pressure Monitoring System
- Steering System
- Restraint
- Brake System
- Body (Interior and Exterior)
- General Information
- Body Dimensions
- Fender
- Hood
- Tail Gate
- Fuel Filler Door
- Front Door
- Rear Door
- Body Side Molding
- Panorama sunroof
- Mirror
- Cowl Top Cover
- Floor Console
- Crash Pad
- Roof Trim
- Interior Trim
- Trunk Trim
- Windshield Glass
- Quarter Fixed Glass
- Floor Carpet
- Front Bumper
- Rear Bumper
- Front Seat
- Rear Seat
- Front Seat Belt
- Rear Seat Belt
- Body Electrical System
- General Information
- Audio
- Multifunction Switch
- Horn
- AVN System
- MTS System
- Smart Key System
- Keyless Entry And Burglar Alarm
- BCM (Body Control Module)
- Seat Electrical
- Fuel Filler Door
- Fuses And Relays
- Indicators And Gauges
- Power Door Locks
- Power Door Mirrors
- Power Windows
- Windshield Deicer
- Rear Glass Defogger
- Windshield Wiper/Washer
- Rear Wiper/Washer
- Electro Chromic Inside Rear View Mirror
- Hands Free System
- Panorama Sunroof
- Lighting System
- Auto Lighting Control System
- Auto Head Lamp Leveling Device
- Immobilizer System
- Rear Parking Assist System
- Button Engine Start System
- Ignition Switch Assembly
- Back View Camera System
See also:
Repair procedures
Removal 1. Remove the front bumper cover. 2. Remove the bolts and disconnect the horn connectors, then remove the high pitch horn (A) and low pitch horn (B). [Disk type] [Shell type] Installation 1. Install ...
Camshaft Position Sensor (CMPS). Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON’T remove the camshaft position sensor while the engine is running or ...
Cargo security screen
Use the cargo security screen to hide items stored in the cargo area. ...
