Hyundai Santa Fe (DM): Idler. Repair procedures - Timing System - Engine Mechanical SystemHyundai Santa Fe (DM): Idler. Repair procedures

Removal and Installation

1.
Remove the drive belt.
2.
Remove the idler(A).
Tightening torque :
53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft)

Check the idler. if it is grease leak or abnormal rotation, replace the idler.
3.
Install in the reverse order of removal.

Drive Belt. Repair procedures
Removal and Installation 1. For release the tension, turn the drive belt tensioner counterclockwise then remove the drive belt (A). 2. Install the drive belt (A). Rotate the drive belt tensioner arm (A) ...

Drive Belt Tensioner. Repair procedures
Removal and Installation 1. Remove the drive belt. 2. Remove the drive belt auto tensioner(A). Tightening torque : 53.9 ~ 63.7 N.m (5.5 ~ 6.5 kgf.m, 39.8 ~ 47.0 lb-ft) Tensioner pulley bolt is left-hands ...

See also:

4WD ECU. Schematic Diagrams
Circuit Diagram 4WD ECU Connector Pin Function 1 CAN communication line (Low) 2 CAN communication line (High) 3 - 4 Pressure sensor signal(+) 5 - 6 Lock mode switch 7 Oil pressure motor B 8 Oil pressure ...

Alternator. Description and Operation
Description The Alternator has eight built-in diodes, each rectifying AC current to DC current. Therefore, DC current appears at alternator "B" terminal. In addition, the charging voltage of ...

Schematic Diagrams
Circuit Diagram Connector Pin Information No. Wire harness connector Panorama motor Blind motor 1 Ground 1 Ground 1 Ground 2 2 Glass status signal / Tool fot glass Glass status signal/ Tool (Parameter) ...