Hyundai Santa Fe (DM): If engine turns over normally but does not start
1. Check fuel level.
2. With the ignition switch in the LOCK position, check all connectors at ignition coils and spark plugs. Reconnect any that may be disconnected or loose.
3. If the engine still does not start, call an authorized HYUNDAI dealer or seek other qualified assistance.
If engine doesn't turn over or turns over slowly
1. If your vehicle has an automatic transaxle, be sure the shift lever is in N (Neutral) or P (Park) and the emergency brake is set. 2. Check the battery connections to be sure they are clean and tight. ...
Emergency starting
Connect cables in numerical order and disconnect in reverse order. ...
See also:
4WD ECU. Schematic Diagrams
Circuit Diagram 4WD ECU Connector Pin Function 1 CAN communication line (Low) 2 CAN communication line (High) 3 - 4 Pressure sensor signal(+) 5 - 6 Lock mode switch 7 Oil pressure motor B 8 Oil pressure ...
Telemetics Unit (TMU). Components and
Components Location
Component Connector Pin Information [Audio type] No. Description No. Description 1 Ground 17 - 2 Ground 18 Battery 1 3 - 19 IGN 1 4 Keypad ground 20 ACC 5 MIC output - 21 Airbag 6 MIC output + 22 Keypad ...
Engine Oil Pressure Warning Light
This warning light illuminates: Once you set the ignition switch or Engine Start/Stop Button to the ON position. - It remains on until the engine is started. When the engine oil pressure is low. If the ...
