Hyundai Santa Fe (DM): Ignition Switch Assembly - Body Electrical SystemHyundai Santa Fe (DM): Ignition Switch Assembly

Start/Stop Button. Repair procedures
Removal 1. Disconnect the negative(-) battery terminal. 2. Remove the driver crash pad lower panel. 3. Disconnect the start/stop button connector (B) after removing the center fascia garnish (A). 4. Remove ...

Repair procedures
Inspection 1. Disconnect the ignition switch connector (B) and key warning switch connector (A) from under the steering column. 2. Check for continuity between the terminals. 3. If continuity is not specified, ...

See also:

Power Window Motor. Schematic Diagrams
Circuit Diagram ...

For best battery service
Keep the battery securely mounted. Keep the battery top clean and dry. Keep the terminals and connections clean, tight, and coated with petroleum jelly or terminal grease. Rinse any spilled electrolyte ...

Engine Control Module (ECM). Repair procedures
Removal When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1) Perform "ECM Neutral mode" procedure with ...