Hyundai Santa Fe (DM): Immobilizer Control Unit. Repair
procedures
Removal
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the driver crash pad lower panel.
|
| 3. |
Remove the knee airbag module.
|
| 4. |
Disconnect the connector of the immobilizer unit
and then remove the immobilizer bolt (A) after loosening a nut.
|
Installation
| 1. |
Install the immobilizer control unit after connecting
the unit connector.
|
| 2. |
Install the crash pad lower panel and knee airbag
module.
|
| 3. |
Connect the negative (-) battery terminal.
|
Repair procedures
Teaching Procedures 1. Key Teaching Procedure Key teaching must be done after replacing a defective PCM(ECM) or when providing additional keys to the vehicle owner. The procedure starts with a PCM(ECM) ...
Antenna Coil. Repair procedures
Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the crash pad lower panel. 3. Disconnect the 6P connector (B) of the coil antenna and then remove the coil antenna (A) after loosening ...
See also:
To defog inside windshield
1. Select desired temperature. 2. Select desired fan speed. 3. Press the defrost button (). 4. The outside (fresh) air position will be selected automatically. If the outside (fresh) air position is not ...
TJ Joint. Components and Components Location
Components [LH] 1. BJ assembly 2. BJ circlip 3. BJ boot band 4. BJ boot 5. Shaft 6. TJ boot band 7. TJ boot 8. Spider assembly 9. Retainer ring 10. TJ housing 11. Housing circlip [RH] 1. BJ assembly 2. ...
Rear Transverse Trim. Components and Components Location
Component Location 1. Rear transverse trim ...
