Hyundai Santa Fe (DM): Inhibitor Switch. Description and Operation
Description
Inhibitor Switch monitors the lever's position(P, R, N, D) and is used
to control gear setting signals.
SS-B Solenoid Valve(ON/OFF). Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Inhibitor Switch. Specifications
Specifications ▷ Type: Combination of output signals from 4 terminals ▷ Specifications Power supply (V) 12 Output type Pin to Pin ▷ Signal Code Table P P-R R R-N N N-D D S1 12V ...
See also:
Room Lamp. Repair procedures
Inspection 1. Remove the room lamp assembly then check for continuity between terminals. [General] [Panorama Sunroof] Removal 1. Disconnect the negative (-) battery terminal. 2. Detach the lamp lens (A) ...
Seat Heater (Air Ventilation). Components
and Components Location
Components ...
Owner’s responsibility
✽ NOTICE Maintenance Service and Record Retention are the owner's responsibility. You should retain documents that show proper maintenance has been performed on your vehicle in accordance with ...
