Hyundai Santa Fe (DM): Inhibitor Switch. Repair procedures
Inspection
|
Power Circuit Inspection
1. |
Disconnect the Inhibitor swtich connector.
|
2. |
Ignition KEY "ON"" & Engine "OFF".
|
3. |
Measure voltge between supplied power and ground at inhibitor
circuit.
|
Signal Circuit Inspection
1. |
Connect the Inhibitor switch connector.
|
2. |
Ignition KEY "ON" & Engine "OFF".
|
3. |
Measure voltages between each terminal and chassis ground during
shift lever changed "P, R, N, D".
Signal Code Table
|
Removal
1. |
Set shift lever to "N" position.
|
2. |
Remove the air duct.
|
3. |
Remove the battery and the battery tray.
|
4. |
Disconnect the inhibitor switch connector (A).
|
5. |
Remove the shift cable mounting nut (B).
|
6. |
Remove the manual control lever (B) and the washer after removing
a nut (A).
|
7. |
Remove the inhibitor assembly (A) after removing the bolts (2ea).
|
Installation
1. |
Install in the reverse order of removal.
|
Inhibitor Switch. Schematic Diagrams
Circuit Diagram ...Shift Lever. Components and Components Location
Components 1. Console upper cover 2. Shift lever assembly 3. Shift cable assembly 4. Shift lever knob & boots assembly 5. Manual control lever 6. Retainer ...See also:
Underdrive Brake Control Solenoid Valve(UD/B_VFS). Schematic Diagrams
Circuit Diagram ...
To turn off the blowers
To turn off the blowers, turn the fan speed control knob to the “0” position. ...
Windshield defrosting and defogging
WARNING - Windshield heating Do not use the or position during cooling operation in extremely humid weather. The difference between the temperature of the outside air and that of the windshield could cause ...