Hyundai Santa Fe (DM): Input Speed Sensor. Description and Operation
Description
Input speed sensor (A) is a vital unit that measures the rate of rotation
of the input shaft inside the transaxle and delivers the readings to the Transaxle
Control Module(TCM). The sensor provides critical input data that's used in
feedback control, damper clutch control, gear setting control, line pressure
control, clutch activation pressure control, and sensor fault analysis.
Transaxle Oil Temperature Sensor. Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Remove the air duct. 3. Disconnect the solenoid valve connector(A). 4. Measure resistance between sensor signal terminal and sensor ground terminal. 5. Check ...
Input Speed Sensor. Specifications
Specifications ▷ Type: Hall effect sensor Operation condition (°C)°F ((-)40~150)) -40~302 Air gap(mm)in. (0.95~1.65) 0.0374~0.0649 Output voltage(V) High 1.18~1.68 Low 0.59~0.84 ...
See also:
Hood Lift. Repair procedures
Replacement • When removing and installing the hood lifter, an assistant is necessary. • When removing the clips, use a clip remover. 1. Using a screwdriver, lift the socket clips (A) up slightly on ...
Engine number. Refrigerant label
Engine number The engine number is stamped on the engine block as shown in the drawing. Refrigerant label The refrigerant label provides information such as refrigerant type and amount. (R-1234yf) ...
Repair procedures
Component Replacement After Deployment Before doing any SRS repairs, use the GDS to check for DTCs. Refer to the Diagnostic Trouble Code list for repairing of the related DTCs. When the front airbag(s) ...
